DAYFORCE - GUIDE TOUCH CLOCK

Employees below the Manager level use the Dayforce Touch clock to punch in and out for shifts and meal breaks. This guide will help as it is used.

Registering Employee Fingerprints

An employee must be enrolled in the touch clock before they can begin using it.
This requires that the employee register their fingerprint in the touch clock.
From the home screen, touch and hold the Welcome to Dayforce message or any section at the top of the screen.
After a few seconds, the application prompts you to enter the admin mode PIN. Do so and tap “Enter”.
You will see the Administrator Mode screen.
Tap “Fingerprint Enrollment”.
The Biometric Mode screen appears.
Select “Enroll Employee”.
Each finger for the employee be placed on the scanner several times.
Once the scan of the first finger is complete, the touch clock will produce an audible alert and a green light will flash.
The employee should lift their finger, at which point the screen below appears to prompt the employee to place a second finger on the scanner.
Ask the employee to do so.
NOTE: To cancel fingerprint enrollment without completing the scan, tap the X button in the bottom-right corner of the screen.

Recording Punches on the Touch Clock

Starting and Ending a Shift

Taking a Meal Break

The employee should tap “Start Meal”
enter their 7-digit employee number
Complete biometric verification.
To clock back in at the end of the meal break, the employee should tap “End Meal”
enter their 7-digit employee number
Complete biometric verification.
- NOTE: The Start Break and End Break buttons have been removed from your screen since we do not want employees to record short rest periods on the clock.

If you have questions or would like additional training, reach out to the HRIS team at hrhelp@mistercarwash.com or call us at 844-529-7392.