Restart after Emergency Shutdown

After the Emergency or Weather is clear and site can operate again the systems need to be started again

Plug all cabinet power cables into a wall outlet or outlets.
Turn on Tripp Lite UPS by holding the Power button until you hear it beep, then release the button.
Turn on the Tripp Lite power strip(s).
Wait three to five minutes for the ISP modem/router and the Meraki Firewall to come online. The light status of these devices should be like those in the photo below.
Turn on the server and manager computer. Both are located near the bottom of the computer rack.
Verify the Micrologic tunnel controller computer and send stationboth have power lights on.
If you are prompted for a username and password on your office monitor (see image below), press the Enter button twice to see your devices. This will allow you to switch between various computers at the store.
Turn on ALL the other computers at your site (i.e., POS, Kiosk, etc.).
Contact the Mister Service Desk if any computers will not come on or will not load Logic Wash.

Turn on converted XPTs:

Turn on Pegasus kiosks:

Turn on the main breakers for the kiosks.
Open the kiosk.
Locate the main power switch.
Turn on the main power switch.
Lock up the kiosk and confirm normal operation.
- NOTE: If your Pegasus kiosk has a black screen, disconnect and reconnect the power cord to the Pegasus computer (see images below),
- It is located inside the kiosk on the left side.
- A screwdriver is required for this step.
- The power cord has a green connector and is toward the back of the kiosk.